hosun lim Apps
USB Serial Control Panel Pro 1.5
Smart phones serial control panel program. USBequipment using Silicon Laboratories CP210X, FTDI FT232 andProlific PL2303, CDC/ACM UART to USB Bridge chips can be used toconnect to your smart phone.Zigbee Chip TI CC2531(USB-Enabled SOC Solution for 2.4-GHz IEEE802.15.4 and ZigBee App) can be used also.You can add frequently used functions as buttons, and then clickthe control button to transmit preconfigured data.- Supported chip: Silicon Laboratories(CP210X), FTDI(FT232),Prolific(PL2303)- ARDUINO Support(FTDI, CDC/ACM)- Supported phones: USB host support smart phones (Samsunggalaxy2/galaxy 3/galaxy note / galaxy note2/Vega racer R3)- Supported Android version: Android version 3.1 (API Level 12)0. Quick Start1) Please use the OTG cable to connect the usb device on your smartphone.2) Smart phone detect usb device, and then asks whether to run.Click OK to run the App.3) Click the "Settings" button (wrench icon) of upper right cornerin order to set serial communication.4) Click the "Save" button.5) Click the "Connect button(phone icon)" of upper right corner inorder to connect to the device.6) Click "add control button"(Plus icon) in toolbar, and then inputname and content to send7) Click the Save button8) Control button will be added in the panel.9) Click the button on the control panel, app will transfer thedata(content) to the device.10) App will show the response from USB device at the receive textview.2. Control button contentBinary data is entered as shown below, you can enter in hex orbinary or decimal- Decimal: @ +숫자 3-digit(0~255) ex) CR: @013- Hex: # + 2-digit hex, ex) CR: #0D- Binary: & + 8-digit binary, ex) CR: &00001101※Escape @, #, &: insert twice in succession in order to send @,#, &Delay between the transmitted data can be entered.- insert delay(ms) in send data between "<%" and "%>"ex) up<% sleep:1000 %>down<% sleep:2000 %>left<%sleep:3000 %>right1) send "up"2) sleep 1 second3) send "down"4) sleep 2 second5) send "left"6) sleep 3 second7) send "right"
Developer Gadget 1.3
This app provides a gadget fordevelopers.Necessary tools will be added in future.- ASCII Code Table- Android ID- Java Environment- System Information- Shell Command Executor- File ExplorerOther functions(Copy/Cut/Paste...) will be developed as soon aspossible.- SAMBA Host/File explorer (list only)Other functions(Copy/Cut/Paste...) will be developed as soon aspossible.- Whois- Sensor Explorer
AVR DUD Lite 1.1
This app is an android version AVR downloadand uploader.Current version supports only usbasp programmer.I has a plan to support other programmer in the future release.Supported features- connect/disconnect to the programmer device using the usbport.- load a hex file.- save a flash and EEPROM data into the file.- read and write a flash memory.- read and write a EEPROM memory- chip erase.- read a fuse bits.- write a fuse bits.- show the target board mcu Information.